|
Welcome to the Frequently Asked Questions (FAQ page). Below, we have tried to answer the most common questions visitors to our Web site may have. If you find that your question is not answered on this page, please email us at info@garagetile.com
Do I need to do anything to my garage floor before installing GarageTile?
No, except for major cracks or missing cement pieces, no skim coating, sealing, sand blasting or detergent washing is necessary. Just sweep or blow out your garage and your ready to install.
What adhesive do I use to attach GarageTile to the floor?
None. GarageTile is a floating floor. No adhesive is necessary.
How long do I have to wait before I can use my garage and drive on GarageTile?
As fast as you install it! You can drive on the floor the same day.
Can GarageTile be installed over a painted floor?
Yes.
Do the tiles require a sealant once I’m done?
No.
How do I clean the tiles?
Ammonia and water will do just fine with a sponge mop. No waxes or sealers should be used. You can use a buffer with a lambs wool pad to buff a clean dry floor to an amazing shine. In fact, you can hose off the floor with your garden hose or a power washer. (under 1300psi).
What tools are required for your tile installation?
A rubber mallet to properly connect the interlocks and a carpet knife or any other cutter suitable for vinyl tiles.
Can I use these tiles outside?
No, tiles are not manufactured for direct exposure to ultraviolet rays.
What are GarageTile tiles made from?
Recycled materials that were destined for our landfills. Environmentally friendly GarageTile tiles make good use of what we would normally throw away.
 Can I use a floor jack?
The tile will hold up fine to just about anything that you can put on it. It is a vinyl product, so it will compress under heavy loads. You can use a floor jack to lift a van or car on the tiles and won’t have any problems. Jack stands with sharp edges will cut into the tile, so be careful with them but floor jacks, engine stands, hoists, bottle jacks, toolboxes, etc. will be fine. You're best off simply putting a small piece of plywood underneath to dissipate the load, or just pop out the tile use the hoist, then pop them back into place
|